3. Forces and stresses, reinforcing and stiffening

Material area: (a) Electronic systems, programmable components and mechanical devices

The following page of notes will cover:

  • Forces acting on mechanical components
  • How mechanical components are strengthened to withstand forces
  • Casing and protecting electronic components


Forces and stresses

Force Definition Examples
Tension
  • Force that pulls materials apart
  • Stretches the object along its length
  • Steel cables in suspension bridges
  • A loaded rucksack strap
Compression
  • Force that squeezes materials together
  • Reduces length or volume
  • Table legs
  • Columns in buildings
Bending
  • Force that deforms material into a curve
  • Combination of tension and compression
  • Bookshelves under load
  • Beams in bridges
Torsion
  • Twisting force causing rotation
  • Creates shear stress within the material
  • Drive shafts in vehicles
  • Turning a screwdriver
Shear
  • Forces act in opposite directions, parallel to surface
  • Causes material to slide along a plane
  • Scissors cutting paper
  • Bolts in machinery under load


Strengthening mechanical components

Method How It Strengthens Example
Choosing a stronger material Steel or brass gears and shafts instead of plastic for heavy loads Steel gears in a power drill
Increasing size and cross-section Thicker shafts and wider gear teeth resist bending, torsion and shear Large drive shafts in vehicles
Heat treatment Hardening and tempering steel parts to resist wear Hardened gear teeth
Bearings and bushes Support rotating shafts and reduce friction and wear Bike wheel bearings
Lubrication Reduces friction, wear and heat between moving parts Greased gears and chains
Ribs and webs Stiffen plastic parts without adding much weight Ribs inside a toy gearbox
Reinforced polymers Glass fibre filled nylon is stronger and stiffer Gears in printers


Casing and protecting electronic components

  • Electronic components are fragile and must be protected from impact, moisture, dust, heat and tampering
  • Casings also protect the user from electric shock and sharp edges

Method Protection Given
Injection moulded casing (ABS, polypropylene) Tough, impact resistant, insulates, can include mounting bosses and clips
Vacuum formed casing (HIPS) Cheap casing for prototypes and low volume products
Rubber seals and gaskets Keep water and dust out (waterproof ratings)
Foam or rubber padding Absorbs shock if the product is dropped
Mounting PCBs on pillars/stand-offs Holds the board firmly away from the case and stops it flexing
Conformal coating (lacquer) Protects the PCB from moisture and corrosion
Heat sinks and vents Stop components overheating
Strain relief on cables Stops wires being pulled out of the circuit



Topic test:

Interactive flashcards:

More from DTBase