3. Forces and stresses, reinforcing and stiffening

Material area: (e) Thermoforming and thermosetting polymers

The following page of notes will cover:

  • The behaviour of thermoforming and thermosetting plastics under forces or stress
  • How the type of plastic, cross-sectional area and depth affect stiffness and strength
  • Strengthening by laminating
  • Fibres as reinforcement in thermosetting plastics


Behaviour under forces

Force Definition Examples
Tension
  • Force that pulls materials apart
  • Stretches the object along its length
  • Steel cables in suspension bridges
  • A loaded rucksack strap
Compression
  • Force that squeezes materials together
  • Reduces length or volume
  • Table legs
  • Columns in buildings
Bending
  • Force that deforms material into a curve
  • Combination of tension and compression
  • Bookshelves under load
  • Beams in bridges
Torsion
  • Twisting force causing rotation
  • Creates shear stress within the material
  • Drive shafts in vehicles
  • Turning a screwdriver
Shear
  • Forces act in opposite directions, parallel to surface
  • Causes material to slide along a plane
  • Scissors cutting paper
  • Bolts in machinery under load

Thermoforming Plastics Thermosetting Plastics
  • Many are tough and flexible (PP, polythene, nylon) and bend before breaking
  • Can creep (slowly stretch) under a constant load
  • Lose strength when hot
  • Acrylic is an exception: stiff but brittle
  • Hard and rigid, resist heat
  • Brittle: crack or shatter under impact
  • Do not soften under heat, so keep strength at high temperatures


Stiffness and strength

  • Depends on the type of plastic, the cross-sectional area and the depth of the section
  • Thicker, deeper sections are stiffer
  • Moulded products use ribs and webs to add stiffness without adding much weight or thickness
  • Curved, domed or folded shapes are stiffer than flat sheet


Strengthening and reinforcing

Laminating:

  • Bonding layers of material together to make a stronger, stiffer sheet


  • Advantages Disadvantages
    • Stronger and stiffer than a single layer
    • Can combine properties (e.g. decorative melamine layer on a strong board)
    • Layers can separate (delaminate)
    • Hard to recycle mixed layers

    Uses: Kitchen worktops (melamine on chipboard), laminated safety glass, GRP boats

    Fibre Reinforcement of Thermosetting Plastics:

    • Thermosetting resins (polyester, epoxy) are brittle on their own
    • Adding fibres creates a composite that is strong, tough and light
    • The form of the fibres affects strength: chopped strand mat gives strength in all directions; woven cloth and long continuous fibres are stronger in the direction they run

    Composite Fibre Uses
    GRP (glass reinforced plastic) Glass fibre in polyester resin Boat hulls, car body panels, canoes
    CFRP (carbon fibre reinforced plastic) Carbon fibre in epoxy resin Racing bikes, F1 cars, tennis rackets
    Kevlar composite Aramid fibre in epoxy resin Helmets, body armour



    Topic test:

    Interactive flashcards:

    More from DTBase