3. Forces and stresses, reinforcing and stiffening

Material area: (d) Ferrous and non-ferrous metals

The following page of notes will cover:

  • How the type of metal and heat treatment affect its ability to withstand forces
  • How natural properties, stock form, cross-sectional area and depth affect stiffness and strength


Forces and stresses

Force Definition Examples
Tension
  • Force that pulls materials apart
  • Stretches the object along its length
  • Steel cables in suspension bridges
  • A loaded rucksack strap
Compression
  • Force that squeezes materials together
  • Reduces length or volume
  • Table legs
  • Columns in buildings
Bending
  • Force that deforms material into a curve
  • Combination of tension and compression
  • Bookshelves under load
  • Beams in bridges
Torsion
  • Twisting force causing rotation
  • Creates shear stress within the material
  • Drive shafts in vehicles
  • Turning a screwdriver
Shear
  • Forces act in opposite directions, parallel to surface
  • Causes material to slide along a plane
  • Scissors cutting paper
  • Bolts in machinery under load


Type of metal and heat treatment

  • The ability of a metal to withstand forces depends on the type of metal and whether it can be hardened or tempered by heat
  • Steels are much stronger than aluminium, copper or pewter
  • Medium and high carbon steels can be hardened (resist wear and indentation) and tempered (become tougher, less likely to snap)
  • Example: A spring is made from medium carbon steel, hardened then tempered so it can flex repeatedly without breaking
  • Annealed metal is softer and bends more easily; work hardened metal is stiffer


Stock form, cross-section and depth

  • Stiffness and strength depend on the metal's natural properties, its stock form, the cross-sectional area and the depth of the section
  • A deeper section is much stiffer in bending (e.g. a beam on its edge)
  • Shaped sections such as angle, channel, tube and I-beams put the metal where it resists bending best, so they are strong but light
  • Tube is stiffer than solid rod of the same weight
  • Folding or ribbing thin sheet metal (e.g. a flange or corrugation) makes it much stiffer

[Diagram placeholder] Cross-sections of flat bar, angle, channel, square tube and I-beam



Topic test:

Interactive flashcards:

More from DTBase